Hello. I have what is probably a simple issue but after quite a lot of time trying to figure it out, I cannot.
I have attached 4 screenshots, named "step1", "step2", "step3" and "step4" - each step is a picture of a sequence of actions I would like to take on a lister window. The first three steps are working fine, but the 4th step is not.
I have reconfigured the CTRL+F keystroke to not only open the ADVANCE FIND panel, but to also close the destination pane in my dual lister, and then to reopen that pane in the same path location when I toggle CTRL+F again. In other words, I want to be able to do a search using the full width of the lister window (therefore, I close the destination pane), but when I am finished by search, I want to reinstate my lister window to what it was before I opened the FIND panel. However, when I toggle to close the FIND panel, I also want to close the FIND RESULTS tab which has been created in the existing source pane - this is what I am unable to achieve.
Here is the code I am using for the CTRL+F keystroke:
Set UTILITY=Find,Toggle
Set DUAL=toggle,dest,right,remember
And this is working perfectly for me. However, I have tried to use "Go" with any of the variants of TABCLOSE so that IF the FIND RESULTS pane is open, it will close. In other words, I'm trying to do this:
Set UTILITY=Find,Toggle
Set DUAL=toggle,dest,right,remember
Go TABCLOSE
It is important that the GO TABCLOSE command does nothing if the FIND RESULTS collection pane is not existent, but to close it if it is existent. I can't seem to find a way to do that. I have specified the command with the argument "coll://Find Results", but this too does not seem to work. If I try to close the "current" tab, the behaviour is not right, even though it seems to me it should work because when I am ending the FIND session, the FIND RESULTS collection pane is the current tab. But that is not working either.
The screenshots attached are:
Step1: My original, starting lister.
Step2: What the lister looks like after CTRL+F, using my reconfigured keystroke.
Step3: What the lister looks like after I have done a search.
Step4: What the lister looks like after I close the FIND panel using the CTRL+F keystroke again.
As you can see, the FIND RESULTS is still open. What I want is for the FIND RESULTS to close. Everything else in the lister is exactly as I want it, except this.
Please help if you can. Thank you.
Todd